Triathlete uses wetsuit maintenance recommendations to take care of wetsuit.

Extend the life of your wetsuit with these wetsuit maintenance recommendations

Wetsuits may help you swim like a shark, but they are actually one of the more delicate pieces of triathlon equipment. Even the most careful wetsuit owner may be shocked to find tiny nicks or tears in the neoprene that occurred during a frenzied transition. Never fear! In many cases, wetsuits can be repaired quickly and easily. Utilize the wetsuit maintenance recommendations below.

Wetsuit Glue

Wetsuit glue allows you to make minor repairs to the suit. Spread the glue on small cuts and tears that do not go all the way through the suit. Pick up the flap of the cut and put the glue inside of the hole the cut has created. Allow suit to dry for 24 hours. If cut or tear is not drying properly, place a small piece of scotch tape over the cut. Do this after the glue has been applied to allow it to dry in place.

Iron-on seam tape

Iron-on seam tape is created specifically for suits to flawlessly match the seams. Set your iron on low heat so that the wetsuit does not burn. Turn the wetsuit inside out. Cut the tape to match the size of the tear or seam separation. Place the tape glue side down on the seam or tear. Slowly apply heat with the iron until the iron-on is firmly in place. After repairing the inside of the suit, turn it right side out. Apply the glue now like in the wetsuit glue instructions above.

Wetsuit care

Taking care of small cuts as they happen will prevent them from becoming unrepairable tears that will retire your suit. There are a few wetsuit maintenance recommendations that will lessen the need for frequent repairs. Grip your wetsuit with the pads of your fingers (as though you were grabbing pizza dough). Avoid using your nails, even when they are short. This will prevent small nicks that develop over time. Also, keep your wetsuit away from hot environments like a car in the summertime so the neoprene will not melt or warp.